Need help with DC dumping - SOHD-167T

[RiMMER]

Hello to everyone,

I have been trying to dump a DC disc with SOHD-167T drive for last 3 hours now, unsuccessfully.

Running windows xp sp2 clean install. Installed ASPI 4.60. Tried with at least 3 firmwares on the drive.
With cover and without cover.

Swap works. But when I try to actually dump the disc, it simply fails.
Once I managed in sector view to read sectors 80 000, then 70 000, 60 000, 50 000, then I run the dump. It dumped 4 MB and failed.

Does anyone have ANY idea what am I doing wrong and WHY it doesn't work?

The drive is listed as supported on the forums so I really have no idea what to do next

Any help is greatly appreciated!

[Jackal]

And the Samsung SH-D162D also failed for you before?

Dunno, I haven't dumped a DC disc in a long while, but there must be something wrong if you can't get 2 supported drives to work.. maybe the trap disc was burned incorrectly?

[Jackal]

Also tell us if you're taking the cover off, or if you're using the escape eject pin.. I remember that with using the escape eject pin, it's really difficult to get a successful swap, especially with the lite-on. When you refresh the TOC it should still show the TOC of the trap disc. If this isn't the case then the swap wasn't successful. I think most of the people were using a USB to ATA converter and had the metal cover screwed off.

Hope someone has the patience to go through every step with you.

[themabus]

does it work better, when you swap with regular audio CD, instead of recorded?

[tossEAC]

I have no probs using SH-D162D, dumps every time, using pin eject method.

I use a Pentium Duo (x64), with winxp, and I don't bother with ASPI 4.60 just CDRWin.

But - and this is a BIG BUTT.

I used to dump, with a much lower spec PC, and most times it would dump ok, but quite often the dump, had errors it shouldn't have had.


Since I swapped the dumping to a much faster PC the dumps dump everytime perfectly.

Maybe this info was of use? But it might have something to do with your PC's specs. Not enough fast memory, or a slow cpu/gpu.

If you think it is the firmware you are using, maybe, I use kreon fw.