Page 1 of 1
Quick question about PSX pregap
Posted: Sat Oct 18, 2014 8:13 am
by Rocket
EAC detect a Track 02 pregap of
0 seconds:
On that picture I go back 150 sectors:
My drive is Slimtype - DVD A DS8A3S (Correction Offset is +6)
What value 'Combined Offset' I must use in EAC?
Re: Quick question about PSX pregap
Posted: Sat Oct 18, 2014 9:44 am
by Sotho Tal Ker
EAC has a bug when there is 1 data track and 1 audio track.
Re: Quick question about PSX pregap
Posted: Sat Oct 18, 2014 10:11 am
by Rocket
So, I must set combined value +8 (+2 and +6) in EAC? Or maybe +7 (+1 and +6)? Or what?
That discs:
Re: Quick question about PSX pregap
Posted: Sat Oct 18, 2014 1:47 pm
by ack2121
Rocket wrote:So, I must set combined value +8 (+2 and +6) in EAC? Or maybe +7 (+1 and +6)? Or what?
That discs:
I would say +8 for EAC in this case if your scrambled sector length is 0x20 (=32/4=8). This assumes that you have a 2:00 pregap (i have seen 3:00 and 4:00 and others on PSX disks too).
Re: Quick question about PSX pregap
Posted: Sun Oct 19, 2014 5:04 am
by Rocket
ack2121 wrote:I would say +8 for EAC in this case if your scrambled sector length is 0x20 (=32/4=8). This assumes that you have a 2:00 pregap (i have seen 3:00 and 4:00 and others on PSX disks too).
Hmmm... Ok. I'll dump Track 2 with +8 (+2 and +6), but dump must be added with Yellow Light status.
Re: Quick question about PSX pregap
Posted: Sun Oct 19, 2014 5:17 am
by Jackal
There's no point in adding dumps with yellow status.. You can try extracting with IsoBuster extract from-to and then correcting the offset with hex editor.. see if it matches EAC dump with dummy pregap added.
Re: Quick question about PSX pregap
Posted: Sun Oct 19, 2014 6:07 am
by Sotho Tal Ker
I thought you have a plextor drive now, Rocket?
