Redump Forum

Hi,

I use MPF.Check to generate a stub !submissioninfo.txt and it places three locations for Mould SID codes into the file

Data Side Mould SID Code: (REQUIRED, IF EXISTS)
Data Side Additional Mould: (REQUIRED, IF EXISTS)
Label Side Mould SID Code: (REQUIRED, IF EXISTS)

I've just submitted my first verification (hopefully correctly!) and noticed the form didn't make a distinction for the Data or Label side. I'm clueless as to whether this is oversite or adjusted behaviour. Thought I'd highlight it. Probably something I'm missing.

Hi

L0 is data side and LS is Label Side in the form. Bit confusing i know since CDs don't have L0 or L1 but were still building the site at the moment.

Thanks for info, Morlit. I expected it to be me. Yeah, I saw the two lines of inputs and thought "OK, so it's not dynamic to the media yet". Now I understand.